XR10 CF Motor Plates

Description

Carbon Fiber Motor Plates for the Axial XR10

These use the big 10mm bearings like the older discontinued VP ones

Direct fit and now with button head screw adaptation. After mounting the upper link to the motor plate you need to check bearing clearance. Do not force the bearings into the carbon, this may cause it to split. 

If any of the bearings are too tight of a fit you can open them up a bit with some easy sanding. The holes are machined with a tolerance to the bearings. Sometimes tool wear may cause some holes to fit tight. Bearings should push in by hand with minimal effort.

Sold in pairs – 1 Set will do a Front and Rear axle setup for an XR10 rig.